I went to the Opal Kelly website again and noticed that there are a lot of menu options that I previously did not notice at the top menu. I found a sample board that uses their SZG-DUALSFP board: https://opalkelly.com/products/xem7320/ So now I can read the documentation for this board and be on my way! I … Read more
So I have the Genesys Zynq UltraScale + MPSoC board, I bought the SZG-DUALSFP from Opel Kelly, and I want to figure out how to wire this thing up. What pin goes where? I dunno. I spent some time reading the SFP+ specification. Everything makes sense. Then I read through the SYZYGY specification. Again, things … Read more
After my previous post showing how to use the NI LabVIEW FPGA IP Export Utility to run LabVIEW FPGA code on a Zynqberry (http://fpganow.com/index.php/2020/09/28/zynqberry-with-breakout-board-and-labview/), I continued following the examples I could find on the internet and was able to connect to the board by using the PS (Processing System) built-int UART, and to communicate to … Read more